add the same user and pw also in the vera area where it asks for the user and pw. 
add this snapshot url address:port/cgi-bin/CGIProxy.fcgi?cmd=snapPicture2&usr=xxx&pwd=xxxĬhanging the ip address, port, user and pw you entered and changed in the foscam utility. now go into the vera and follow the procedure for adding the camera as you did before. disconnect Ethernet cord and close and re-open the utility, enter new user and/or pw, you should be able to get a picture. change each of them, especially pw and port, and save and wait for it to reboot. in this utility you can change the camera port, username and password. there is a list of things on the left side you should go through and add any info that is required. If it has been changed then enter the new user and pw double click the camera ip address and it should open a foscam utility - if the user and pw have not been modified then. you should get a window with the ip address and port of the camera. download IP Camera Tool from the foscam website and run. connect the camera to your router thru Ethernet cord. The best way I have found to get a 910 to work is as follows. Unfortunately, entering the user info on the URL in the Vera setup doesn’t work although it does work on the URL in a browser. So this is what leads me to think the Foscam software is messed up and not accepting the user info from the dialog. However, when I try to enter the info in the dialog, it just loops and keeps showing the dialog. I believe this is coming from the camera and not Vera since I can reproduce the same behavior from a browser when I don’t include the uname and password in the URL. In some cases, I am prompted to enter the username and password. I tried some variations of the URL to the camera, for example I tried and even tried None of the above seem to work. 
I then enter all the requested info, but when I click Next the page displayed says that if you don’t see an image from the camera you did something wrong… I don’t see any image.
In VeraPlus, I choose Add “Other IP Camera”. I think the problem is in the camera software, but haven’t been able to fully prove it yet. Have you had any luck getting this to work? I have been trying to add a Foscam FI8910w to my VeraPlus without much luck.
0 kommentar(er)
